中塑资讯

news center

  • 行业资讯

    当前位置: 网站首页 > 中塑资讯 > 行业资讯

    • HDPE储罐怎样清理?
    • 本站编辑:湖北中塑环保科技有限公司发布日期:2022-05-10 16:36 浏览次数:

    每次制造完毕后,用抺布将HDPE储罐表面清洗整洁,严禁用很多的水持续清洗机器设备外界,防止隔热层毁坏。

    按加工工艺规定,制造一定時间后,解决罐里开展清理。长时间,超出72钟头,停工后,开课前机器设备应再次清理。

    清理规范,单种类应用的机器设备清理至不可以发觉可视性脏物;好几个种类应用的同一台机器设备在拆换种类时按加工工艺规定实行。

    清理实际操作人应立即填好清理纪录,工作经验收入工程验收并签名确定。

    进到HDPE储罐中清理该罐时应按标准规定的要求开展。进到机器设备内清理时,应在釜底铺平海绵垫,以防专用工具掉入,并须穿胶底鞋,以防损害夹层玻璃面。

    储罐的筒夹内禁止进到酸液。如果清理筒夹一定得用酸液时,不可以用pH<2的酸液,酸液进到该机器设备夹套会造成氢效用,造成表层像鱼鳞片大规模掉下来,一般清理筒夹能用百分之二的次氯酸钠溶液,再自来水清理筒夹。

    After each manufacturing, clean the surface of HDPE storage tank with cloth. It is strictly prohibited to continuously clean the outside of machinery and equipment with a lot of water to prevent the damage of thermal insulation layer.

    According to the processing technology, clean the tank after manufacturing for a certain time. For a long time, more than 72 hours, after shutdown, the machinery and equipment shall be cleaned again before class.

    Cleaning specification: separate types of machines and equipment shall be cleaned so that no visible dirt can be found; For the same machine and equipment used in several types, it shall be replaced according to the processing technology regulations.

    The actual cleaning operator shall immediately fill in the cleaning records, and the work experience shall be included in the project acceptance and signed for confirmation.

    When entering into HDPE storage tank and cleaning the tank, it shall be carried out according to the requirements specified in national standards. When entering the machinery and equipment for cleaning, the sponge pad shall be paved at the bottom of the Buss to prevent special tools from falling in, and rubber soled shoes shall be worn to prevent damage to the laminated glass surface.

    No acid is allowed into the collet of the storage tank. If the acid solution must be used to clean the collet, the acid solution with pH < 2 can not be used. The acid solution entering the jacket of the machine and equipment will cause hydrogen effect and cause the surface to fall off like fish scales on a large scale. Generally, the collet can be cleaned with 2% sodium hypochlorite solution and tap water.

    返回顶部